Hubei''s First Substation Based Energy Storage Project

Is Kiribati launching a solar PV project?

The Oceania located nation of Kiribati has started construction on the country's largest solar PV project that's backed by the Asian Development Bank and the Government of New Zealand. It will be accompanied by a battery energy storage system (BESS). The 7.5 MW South Tarawa Renewable Energy Project (STREP) is located on the Bonriki water reserve.

How will Kiribati transform the energy sector?

The proposed project will initiate and contribute to the transformation of the Kiribati energy sector to one that is low-carbon and adapted to growing climate and natural hazards. It will do this by installing the innovative, climate-adapted and efficient floating PV (FPV) for power generation and for services and benefits beyond electricity.

Who financed the South Tarawa water supply project?

Supported by the bank and co-financed by the Kiwi government, the project's solar and BESS components were procured under the ADB's South Tarawa Water Supply Project co-financed by the World Bank and the Green Climate Fund.

What is a battery energy storage system (BESS)?

1. Introduction A typical modern Battery Energy Storage System (BESS) is comprised of lithium-ion battery modules, bi-directional power converters, step-up transformers, and associated switchgear and circuit breakers.

What is a 66/12 kV substation?

The line is a 12-kV distribution circuit fed from a 66/12 kV substation that feeds approximately 10 MW of load and has 7.5 MW of solar PV generation interconnected at different locations on the circuit. The BESS and solar plant modeling is described in the following sections. Fig. 2.

What is a general energy storage system?

In, a general energy storage system design is proposed to regulate wind power variations and provide voltage stability. While CAES and other forms of energy storage have found use cases worldwide, the most popular method of introducing energy storage into the electrical grid has been lithium-ion BESS .

Where can I find the power output of a PV system?

Although the actual PV system data is largely unknown, the power output of the PV installations on the circuit was able to be retrieved from the SCE distribution engineering department. In addition, the location of these plants is also accurate relative to their distance from the BESS and substation.

How does Bess model a battery energy storage system?

The BESS recovers the feeder voltage linearly from t = 1 s to t = 3.5 s. The loads are modeled using the circuit load profile and typical distribution power factor values but were varied for different study cases. The overall model along with developed control systems is shown in Fig. 2. 2.1. Battery energy storage system modeling

How many solar arrays are in a 3 MW PV plant?

For the 3 MW plants, there are two solar arrays, each comprised of N = 20 series connected modules and M = 180 parallel strings. Fig. 6 shows one of the 3-MW PV plants in the system model. Simulink offers a wide variety of different PV array modules to model PV plants. For this model, the PV arrays are modeled with SunPower SPR-415E-WHT-D modules.